Robotronics Buzz E Instruções de Operação descarregar pdf (Página 48)

Appendix A: Quick Reference Troubleshooting Chart

Problem Cause Solution

One of the eyelids is at a different level 1. Eyelid rod bent or eyelid out of adjustment 1. Straighten bent rod or change eyelid position by

removing the servo arm. Then shorten or

lengthen the rod by twisting the servo arm. You

can also change the position of the servo arm on

the servo shaft.

1. Connection at eye servo board has come off. 1. Vehicle- located on underside of upper robot.

Robots with Character- located in character.

2. Wire(s) bringing 5 Volts and signal to servo

board are not making a connection. Broken

out of 37 pin connector.

2. Vehicles- locate the wires

(red/black/gray/yellow/black) going from the 37 pin

up to the eye servo board. Repair broken wiring.

Robots with Character- Check gray/yellow/black

and red black to eye servo board.

No operation of any eye functions.

3. No 5 Volts going to eye servo board. 3. Find broken wire on red/black or check fuse for

eye servos on fuse block.

1. In-line fuse blown.

1. Replace the 5 Amp fuse which is in-line on the

wire. Follow wire from water squirter switch.

Water Squirter

Cannot fill reservoir

2. Broken wire at water squirter switch or

coming from main box

2. Repair break.

1. Water squirter switch is not in on position. 1. On position is not the center position. Cannot squirt: no pump sound.

2. Broken wire at pump or W.S. switch. 2. Repair/re-solder broken wire.

1. Reservoir empty 1. Fill Reservoir with filler bottle.

2. Water line is not connected to water

connector

2. Connect it.

Cannot squirt: pump sound yes

3. Overflow tube and squirt tube are switched

at the reservoir.

3. Swap them back. Overflow tube is the one that

is in the top of the bottle and the tube runs to an

outlet on the bottom of the frame.

1. Modifier not turned on.

1. Push pedal on modifier. Light should come on.

Voice Modifier

Voice not being modified

2. Audio wires not plugged in correctly

2. Jumper wire goes from Nady Receiver to Input

of Modifier. Wire in Output A of modifier goes to

the main board.

More detailed troubleshooting by system is included with each subsystem. For additional help or parts

call our service dept. at 801-489-4466.

1 2 ... 43 44 45 46 47 48 49 50 51 52 53 ... 60 61

Comentários a estes Manuais

Sem comentários

Robotronics Buzz E Instruções de Operação Página 48

Comentários a estes Manuais

Manuais e produtos relacionados com Detetores de fumo Robotronics Buzz E